|
GYAF1
All-in-One, Flat Head The GYAF1-probe is an all-in-one type sensor with integrated controller. After supplying DC 24V to the probe, an analogue voltage and/or current, which are proportional to the position of the magnet, can be obtained. Reversed output or bipolar output can be supported as well. The flat head permits a miniaturized application, and the flange makes the installation easier, compared with the conventional screw type probes Model Selection
|
Dimensions
Material probe head:SS304, probe rod:SS304
Standard magnet:No.2PN. Other magnets are available from Magnet Grouping [GG].
The tip dead zone length (70mm) depends on the magnet or float type.
The length of the cable should be less than 10m in case of using the voltage output type and
100m in case of using the current output type.
CN type: Sanwa SNW-1607-PCF (Material:zinc alloy fluoroplastic), WPCN type: Tajimi TC1108-12A10-7F (8.6)
(Material:brass with Ni plating)
Wire size:less than 0.5mm2
The figure in < > is the figure of IP68 type (WPCN, WPG*).
Applicable O ring type is P-14. Back-up ring is strongly suggested in usage.
Standard magnet:No.2PN. Other magnets are available from Magnet Grouping [GG].
The tip dead zone length (70mm) depends on the magnet or float type.
The length of the cable should be less than 10m in case of using the voltage output type and
100m in case of using the current output type.
CN type: Sanwa SNW-1607-PCF (Material:zinc alloy fluoroplastic), WPCN type: Tajimi TC1108-12A10-7F (8.6)
(Material:brass with Ni plating)
Wire size:less than 0.5mm2
The figure in < > is the figure of IP68 type (WPCN, WPG*).
Applicable O ring type is P-14. Back-up ring is strongly suggested in usage.