GYHR

 

		The GYHR probe, including also the sensor head, in order high temperature (the highest 100℃) in atmosphere to operate to stability, is the displacement sensor which is designed. While holding down number of articles to minimum, it has been compatible high efficiency and reliability. Inside of the sensor head is designed to be complete sealed structure, resistance noise characteristic is raised. 2 line systems of new development are adopted to interface between the probe and the controller. We multiplex the bidirectional signal in the power source line, we maintain the resistance noise characteristic which is equal to former GYcRP type. We use the strengthening silicon rubber sheath of the heatproof temperature 150℃ to the connector cable, it is extension possible to longest 100m.

Specifications

Precision Linearity Below ±0.1%FS Resolution Below ±0.01%FS Repeatability Below ±0.05%FS (hysteresis is included) Temperature drift 22 millimicrons/℃+50ppmFS/℃ Environmental characteristic Resisting pressure Maximum 35MPa Specification temperature range -5 - 100℃ Storage temperature range -40 - 120℃ Resistance swing characteristic 6G (or 40Hz 2mmPP) Chip resistance 50G (2msec) Protective standard IP64

* The above-mentioned specification is applied in case in 300mm stroke.

Type Variations
		Effective stroke (mm) max2000mm
		When it is above stroke 1000mm, basis dead zone 120mm and advanced dead zone 120mm it is necessary.
		Rod diameter
		8: φ8 (standard) Blank: φ10
		Direct putting out cable length (m)

External Dimensions Drawing

●GYHR probe Material probe head: SUS304 　　　Probe rod: SUS304 GYHR you use the probe, combining with GYMNC-20 analog or the GYDC-03A digital type controller. Standard is the cable gland.