GYLT/GYLS

 

		GYLT and the GYLS probe are all in one type sensor of low cost. With the adoption of new detection system, signal-noise ratio above approximately 10 time improvement (this corporation ratio). Low low cost conversion and field work simplification were assured with electric power consumption and the adoption etc of the screw wiring type connector. There are 2 types of electric current output and voltage output.

 

Specifications

Precision Linearity ±0.025%FS TYP Resolution Below 0.01%FS Repeatability Below ±0.01%FS Temperature characteristic Below 40ppm FS/℃ Output Electric current output Type GYLT 4 - 20mA (below load resistance 500Ω) Voltage output Type GYLS 0 - 10VDC (load current max5mA load resistance min2kΩ) Supply power source DC24V±2V 0.05A Frequency characteristic Scanning frequency 1kHz (standard) Environmental characteristic Resisting pressure 35MPa Category temperature range -20℃ - 80℃ Storage temperature range -40℃ - 80℃ Resistance swing 6G (or 40Hz2mmPP) Shock resistant 50G (2msec) Protective standard IP67 (10kPa and 30min)

* The above-mentioned precision is applied when it is above effective stroke 300mm.

Type Variations
		Effective stroke
		max3000mm
		Operational direction (to rod point when moving)
		D: Increase operation R: Decrease operation
		Installation screw
		M: M24×P1.0 (standard) N: M18×P1.5 U: 3/4-16UNF
		Shaft diameter
		Blank: Φ 108: Φ 814: φ13.8
		Cable removal
		As for connector type non entry G*: [piguteiru] type (* cable length m)

As for the magnet No.2PN type belongs usually.
The connector can choose straight type or light/write angle type.

External Dimensions Drawing

●GYLT/GYLS probe Material probe head: Aluminum alloy 　　　Probe rod: SUS304 Connector connection 1 DC24V 20 V 3 outputs (electric current or voltage) 4 COM * At user side you connect the seal to 0V. 0V and COM are connected in inside. <[piguteiru] type (option)> * Use connector Omuron XS2C-D4S1 or D4S2 * Application cable major diameter: φ5 - φ6 application electric wire size: 0.18 - 0.75 squares mm Furthermore note) the connector can select also SNW-1607-PCF.