GYPM

 

		The GYPM probe the former GYMT type probe compared to furthermore is the probe of the new model which miniaturizes the sensor head section. By the new design inside the sensor head, the dead zone of screw side was shortened to 30mm. In addition the advanced dead zone is shortening possible to 40mm with option. With GYPMC-02 controller of the new design or GYPMC-01 of mini- case type, either of the GYMNC-20 controllers you can use combining.

Specifications

Precision Linearity ±0.05%FS Resolution 0.01%FS Repeatability 0.01%FS Temperature characteristic ±70ppm FS/℃ (probe) ±50ppm FS/℃ (controller) Output GYPMC-01 (it does gain fine control with 5V standard. ) 　　　(Sampling approximately 870Hz) 　　　　0.1V - 9.9V 　　　　　Load current max 5mA 　　　　　Load resistance min 2kΩ GYPMC-02 (it does gain fine control with 0V standard. ) 　　　(Sampling approximately 1kHz) 　　　　0 - 10V 　　　　　Load current max 5mA 　　　　　Load resistance min 2kΩ 　　　　4 - 20mA 　　　　　Load resistance max 500Ω GYMNC - 200 - 10V/4 - 20mA (The same as GYPMC-02. However the temperature drift of the probe becomes ±300ppmFS/℃) Supply power source GYPMC-01 +12VDC (±0.5V and 0.1A) GYPMC-02 +24VDC (±2V and 0.1A) GYMNC-20 +24VDC (±2V and 0.1A) Environmental characteristic Resisting pressure 35MPa (probe rod) Category temperature range -5℃ - +60℃ (probe) 0℃ - +60℃ (controller) Resistance swing 6G (or 40Hz 2mmpp) Shock resistant 20G Protective standard IP64 Cable 1.5m attaching (option max100m)

* The above-mentioned precision is applied in case of the sensor above effective stroke 300mm.

Type Variations
		Effective stroke (mm)
		max1000mm
		A: 0 - 10V
		B: 4 - 20mA
		D: Direct action
		R: Opposite operation
	Note) as for form of the magnet which is used please refer to the column of the GYMS series.

External Dimensions Drawing

●GYPM probe - Controller (GYPMC-02) - Controller (GYPMC-01, GYMNC-20 commonness) The output adjustment of ●GYPMC-01 When the ○ magnet invaded the dead zone of screw side, the signal below 0.05V does not come out, (with 0.05V saturation) ○ gain adjustment does 5V in standard.